Installation PLANNING
You can easily install a Eureka central vacuum in any new or existing home. Please read these instructions
completely before the first installation. These instructions are specific to the Eureka central vacuum installation.
Choose Inlet Valve Location Use a 9m
measuring tape or vacuum hose to
establish location of inlet valve.
Choose Power Unit Location The power
unit power supply cord needs to have a
grounded electrical receptacle. Make
sure you have room to remove the top lid for changing the
filter bag. The Eureka central vacuum may be mounted in
any of the three orientations pictured. There is a 4-way wall
mount enabling the unit to slide in from any direction. Onc
the desired location is found, anchor the
wall mount in place with (4) # 10 screws.
Allow enough room to slide the power unit
into the wall moun
e
t.
NOTE: Exhaust air is not to be vented
into closed/sealed spaces.
Install Power Unit-Important! Slide power
unit into the 4-way wall mount. Connect
flex hose, PVC pipe, or Auto Utility to the
“arrow in” power unit intake. Attach low volt wire to Wall valve or Auto utility. If you desire to exhaust the power unit,
attach to the “arrow out” exhaust port on the power unit. Finally, connect power cord to Grounded outlet.
CAUTION:
MOUNT
unit at least 15 cm from
sidewalls and allow enough
room to remove bag.
NOTE: A Thermal Cut-out protector is
incorporated into each unit to protect the
equipment from overheating or power
overload.
NOTE: Do not exhaust into
enclosed/sealed spaces.
Test System Vacuum is automatically
activated when hose is inserted into inlet.
Check to ensure power unit operates from
each inlet valve.
