16
SETTING UP THE MACHINE
MOUNTING THE SQUEEGEE
Follow the instructions below to mount the squeegee to the machine:
park the machine on a flat surface, put on the brake (if available) and remove the key (if available);
1
Position the squeegee lever into position 1 (raised
position).
Fit in the squeegee (position A) into the squeegee
support (position C).
Once the squeegee is fitted completely, secure the
knobs (position B).
Connect the squeegee hose from the straight side
(position 1) into the special seat located on the
bottom of the tank and press down hard until it fits
into place completely.
Mount the other end of the hose, from the roll-up
side (position 2) into the squeegee.
The hose’s curve will be used as an anti-drip
device
ADJUSTING THE SQUEEGEE
There are 2 types of adjustments that can be carried
out on the squeegee:
Inclination adjustment
with knob (position 1).
It adjusts the inclination of the squeegee in order to
have a constant pressure over the entire length of
the blade (position 2).
Turn the knob counter-clockwise if there is too
much pressure on the outer points and little
pressure on the central area.
Turn the knob clockwise if there is little pressure on
the outer points and too much pressure on the
central area.
To make the adjustment lower the squeegee, turn
on the suction fan and drive forward slowly.
Examine the pressure distribution on the blade and
if necessary correct the inclination as described
above.
Summary of Contents for E51 BASE
Page 2: ...3...
