24
For the TRAC and ECO versions, enable the brush function using the button in the instrument
panel; the brushes will not start rotating until the drive command is enabled.
Turn on the suction fan using the special button in the instrument panel.
For the TRAC and ECO versions, set the desired maximum operating speed using the
potentiometer located in the instrument panel.
For the BASIC and TRAC versions, use the valve to adjust the quantity of the solution in the
brushes.
For the ECO version, set the maximum quantity of the desired solution using the + and – keys.
This version is fitted with an electronic solution dosing unit that operates in proportion to the
speed of the machine and provides a constant and exact quantity of solution on the brush,
preventing any waste. When the machine slows down, the flow of the solution automatically
decreases and when the machine speeds up, the flow of the solution increases until reaching the
maximum flow once the maximum speed is reached.
To avoid damaging the floor,
be very careful not to halt the machine over the same floor area while the brushes
continue to operate.
For the BASIC version, make sure to turn off the brush using the button in the instrument panel
when coming into a stop position and shut off the water using the manual valve.
For the TRAC and ECO versions, the brush will stop automatically after 3 seconds when the drive command is
released and the solenoid valve will also shut off the flow of the solution. When resuming the drive operation, the
brushes will restart and the solution will automatically start to flow.
If the squeegee leaves wet lines on the floor during the washing operation, it means that there are pieces trapped
beneath the rear rubber wheels of the squeegee. Lift the squeegee and remove the trapped pieces. Use a cloth to wipe
off the rear rubber wheels if the pieces cannot be removed manually. In any case, it is always advisable to sweep the
floors before washing.
Make sure to check the level of the solution present in the clean water tank through the clear pipe.
For the BASIC and TRAC versions, once the detergent solution is used up, take the machine to the tank drainage area,
drain the dirty water into the appropriate location, ready for disposal, then wash the water tank and fill up the tank with
clean water and a mix of water and detergent solution, then resume the washing operation.
On the ECO version, once the solution is used up, the machine can continue its washing operation
using the ECO SYSTEM function that can be enabled by pressing the button located in the
instrument panel, this will enable the machine to re-use the water from the recovery tank as it is
duly filtered by the special tank filter. The ECO SYSTEM device can be enabled at the operator’s
discretion
whenever the clean water level drops to ¼ of the tank.
However, if the ECO SYSTEM is started when there is still some solution left in the clean water tank, the operation
can be deactivated at any time and it is possible to resume washing using the solution from this tank.
When using the ECO SYSTEM mode, the water is also distributed according to the speed of the machine, therefore
the maximum quantity of water will flow when the machine reaches its maximum speed.
It is advisable to run a pre-wash operation before washing very filthy floor surfaces.
The machine is also fitted with a float valve that shuts off the suction function when the water level in the dirty water
tank is too high.
Under standard machine operating conditions, when filling the clean water tank accordingly, the float valve will never
be activated, unless the machine is handled roughly or the floor surface level is uneven. If the suction fan operation
stops (which can be easily noticed as the noise of the suction motor will stop and the machine will no longer vacuum),
open the lid and make sure the balls located in the float valve have dropped to release the suction function, then
resume the operation.
When completing the washing operation make sure to switch off the brushes using the special
buttons according to each version; for the BASIC version, shut off the water valve, lift the
brush plate and the squeegee, then
turn on the suction function and take the machine to the
tank drainage area.
The suction function is left in on-position to keep water from leaking out from the lid in case there are uneven areas on
the floor while going to the tank drainage area.
