20
MOUNTING THE BRUSH OR ABRASIVE DISC ON MACHINE
Follow the instructions below
to mount
the brushes or
disc pad holders with abrasive discs:
Turn off the machine and press the key into
position 0.
Lift the brush plate (pos.2) with the pedal (pos.1).
Position the brush or disc pad holder (pos.4) under the brush
plate lifting the splashguard (pos.3) and centre it with the plate.
Slowly lower the brush plate with the pedal (pos.1).
Go into drive position and move the machine from right to left
and vice versa until the brush fits into place correctly on the
centre of the plate.
Rotate the key-operated switch (pos.1) and wait till
the battery charge level is no more visible on the
display. At this point the starting-up sequence is
complete.
Put the potentiometer for speed adjustment into min. position by pressing it towards the drawing
of the turtle, on the label.
Push the brush switch to activate the brush. The brush does not rotate when the green light is on.
Slowly push forward the drive control and release it as soon as the brush starts rotating. The brush motor will rotate for
2 seconds thus allowing for the brush release. Repeat the same operation again if necessary.
