43
5
°
SERVICING AND MAINTENANCE FOR SCHEDULED
SERVICING OF E51 M - E61 M - M510 M - M610 M
AFTER 500 HOURS
DATE
DAY
MONTH
YEAR
WORKING HOURS
MOTOR CARBON BRUSHES CHECKS
CHECK AND REMOVE THE MOTOR CARBON BRUSHES ONE AT A TIME SO AS NOT TO INVERT THEM. THE
MOTOR CARBON BRUSHES SETTLE AND WEAR DIFFERENTLY THE ONE FROM THE OTHER,
CONSEQUENTLY IF THESE ARE INSPECTED AND PUT BACK ON AGAIN BECAUSE THEY ARE NOT FULLY
WORN, THEY MUST BE REFITTED IN THE SAME POSITION.
VACUUM MOTOR
Check the carbon brushes (2 in all) and replace them if they’re shorter than 6 mm.
The length of a new carbon brush is 25 mm.
BRUSH MOTOR
Check the carbon brushes (4 for each motor) and replace them if they are shorter than 4 mm.
The length of a new carbon brush is 19 mm.
TRACTION MOTOR
Check the carbon brushes (4 in all) and replace them if they’re shorter than 7 mm.
The length of a new carbon brush is 20 mm.
MACHINE
Check that the batteries clamps are not loosen or oxidizes
Check the cover gasket
Check the vacuum motor filter
Check the brake
Check, and replace if necessary, the fuses
Check the brushes and the components of the brush plate
Check, and if necessary rotate or replace, the squeegee blades
Check the adjusting/closing detergent solution tap
Check the drainpipes of the solution and recovery tanks
Check that the vacuum pipe of the squeegee is not blocked or clogged
Check the wheel bearings
Check the squeegee lifting lever and its cable
Test the machine in all its operating functions
THE SCHEDULED SERVICING WAS CARRIED OUT BY:
NAME: _______________________________________________
SURNAME: ___________________________________________
SIGNATURE: __________________________________________
DISTRIBUTOR’S STAMP
NOTE:
