FILTER
REPLACEMENT
⇒
Shake accurately filter
⇒
NOTE – REMOVE THE KEY FROM THE IGNITION AND DISCONNECT THE
BATTERY
⇒
Open hopper hood pos.18
⇒
Remove screws pos.10 springs pos.9 and the filter fixing nuts pos.8-7-6
⇒
Raise the filter and disconnect the connector pos.14
⇒
Position the filter on a table
⇒
Unscrew the locking screws of the motorized shaker pos. 15
⇒
Remove the motorized shaker pos.12
⇒
Remove the remaining screws and undo the two plates pos.13
⇒
Remove the bars pos 17 and the spacer bars pos. 16 from the filter.
⇒
Remove locking plates pos.11
⇒
Remove filter support pos.4
⇒
Replace filter pos.5
⇒
Reassemble all the parts by following the above phases in reverse order
⇒
Check that the sealing pos. 1 is in good condition and, if necessary,
replace it.
⇒
Reassemble all being careful to insert connector pos. 14 correctly.
⇒
Screw filter blocker pos.10 until spring pos.9 is compressed in a length
of 25 mm as indicated on label pos.3
FUSE
REPLACEMENT
⇒
Turn off engine.
⇒
Open hopper hood pos.18
⇒
Remove front mask.
⇒
Lift protection rubber panel pos.19
⇒
Open fuse holder pos. 21
⇒
Replace damaged fuse with spare part pos.20
⇒
Reassemble all.
⇒
Note! Do not change the resistance value of the fuse.
31
Summary of Contents for MAGNUM 901 EB EVOLUTION
