9
OPERATIONS
ASSEMBLY OF STORAGE BASE
1.
Insert storage base shaft into slot on base until it clicks into place. Ensure side of shaft that says
Floor Nozzle goes in the same side as wheel well.
2.
Detach hand vacuum from wand
3.
Keep wand attached to floor nozzle and place in the wheel well rest on storage base
4.
On back of hand vacuum, slightly below the vent, locate the notch
5.
On upright portion of storage base locate the hook
6.
Align notch on hand vacuum so it rests on storage base hook
7.
Wrap power cord either around the cord wrap hooks on the wand or around the hand vacuum.
8.
Tools can be stored on the two side mounts
Note:
When lifting unit on storage base always make sure hooks are properly engaged with both the wand and
the hand vacuum
Click
！
Tool base assembly
