ST122 -10 - JAN.
2008
ENGLISH
MAINTENANCE SCHEDULE
The chart below lists basic engine maintenance. Refer to engine manufacturer’s Operation Manual for additional
information on engine maintenance.•
After
use
Every
8-15 hrs.
or
before each
daily start-up
Every
250 hrs.
Every
year
Clean the machine well.
•
Check oil level.
•
Check combustion and cooling air intake zone.
•
Clean air cleaner.
•
Check for oil leaks.
•
Change engine oil and clean the oil filter.
•
Clean cooling air area.
•
Check that all bolts are tight.
•
Apply grease to the 4 grease nipples on the
spider block.
•
Siphon water out of fuel tank.
•
SEE PICTURE 19 PAGE 30
INSTRUCTIONS FOR LIFTING MACHINE
•
Never walk or stand under a machine being lifted.
•
Use only the frame lifting hook (1) for lifting the machine.
equipment.
•
Use only tested and authorised lifting
SCRAPPING
In the event of deterioration and scrapping of the machine, the following items must be disposed of in
accordance with the requirements of the legislation in force.
Main Materials:
1. Engine : Aluminium (AL), Steel (AC), Copper (CU), Polyamide (PA)
2. Machine : Steel sheet (AC)
The instructions for use and spare parts found in this document are for information only and are not
binding. As part of our product quality improvement policy, we reserve the right to make any and all
technical modifications without prior notice.
Summary of Contents for M12800
Page 2: ...ST122 1 JAN 2008 ENGLISH PAGE 2 DEUTSCH SEITE 11 DANSK SIDE 20 ...
Page 30: ...ST122 29 JAN 2008 HONDA GX 160 ...
Page 31: ...ST122 30 JAN 2008 ROBIN EX17 ...
Page 43: ......
