5
2.
Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair,
clothing, and gloves away from moving parts. Loose clothes, jewelry, long hair and fabric
gloves can be caught in moving parts.
3.
Avoid accidental starting. Be sure that the air inlet control knob is OFF before connecting the
air tube. Machines that have the knob in ON position may cause accidents.
4.
Never place hands, fingers, gloves or clothing near cutting area or rotating machine parts.
5.
Remove adjusting tools before turning the machine ON. A wrench or a key that is left
attached to a rotating part of the machine may result in personal injury.
6.
Do not overreach. Keep proper footing and balance at all times. Proper footing and balance
enables better control of the machine in unexpected situations.
7.
Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes, hard
hat, or hearing protection must be used for appropriate conditions.
8.
Always use supplied safety chain during any work on non-horizontal objects. Mounting can
release.
MACHINE USE AND CARE
1.
Do not exceed the recommendation for maximum drilling diameters to prevent overload. It
could cause premature malfunctions that may result in rubbing and friction.
2.
Use suitable oil for the air lubricator on your air supply unit and keep it at level. The wrong oil
or insufficient oil may damage the pneumatic drilling machine.
3.
During drilling operations, drills must be lubricated with good quality cutting oil.
4.
To prevent injuries, make sure that the ejection direction of the slug is shielded.
Alternatively, remove the slug from the annular cutter after each hole.
Caution, the slug may be sharp and hot!
5.
Avoid spilling cutting oil. Apply EUROBOOR cutting paste or spray when using the machine on
non-horizontal surfaces.
6.
Use clamps or other practical way to secure and support the work piece to a stable platform.
Holding the work by hand or against your body is unstable and may lead to loss of control.
7.
Do not use the machine if the magnet and air control knob can’t turned ON or OFF. Any tool
that cannot be controlled with the knob is dangerous and must be repaired.
8.
Switch OFF the air supply and disconnect the tube outlet connector from the machine before
making any adjustments, changing accessories, or storing the tool. Such preventive safety
measures reduce the risk of starting the tool accidentally.
9.
Store idle machines out of reach of children and other untrained persons. Tools are
dangerous in the hands of untrained users.
10.
Maintain machines with care. Keep cutting tools sharp and clean. Properly maintained tools,
with sharp cutting edges are less likely to bind and are easier to control.
11.
Check for misalignment or binding of moving parts, breakage of parts, and any other
condition that may affect the machine operation. If damaged, have the tool serviced before
using. Many accidents are caused by poorly maintained tools.
12.
Use only accessories that are recommended by EUROBOOR for your model. Accessories that
may be suitable for one machine, may become hazardous when used on another machine.
Summary of Contents for AIR.55
