www.euroboor.com
22
4.2 Adjusting the machine speed
The EBS.500 is equipped with variable cutting speed.
The machine speed can be adjusted from minimal 30
m/min (100 ft/min) to 80 m/min (265 ft/min). This
adjustment can be made by turning the machine speed
knob, which is on the motor housing.
Knob position
Machine cutting speed
1
30 m/min (100 ft/min)
2
40 m/min (133 ft/min)
3
50 m/min (166 ft/min)
4
60 m/min (199 ft/min)
5
70 m/min (232 ft/min)
6
80 m/min (265 ft/min)
4.3 Setting cutting angle
The EUROBOOR EBS.500 has the capability to
make cuts from 0° to 60° angles. Be sure that the
correct angle is set before you start working with
the machine. For setting the correct angle, follow
below steps.
1.
Loosen the ‘Angle lock screw’ (Image 4-3). By turning the angle lock lever counter-
clockwise the screw will be loosened. By lifting the angle lock lever slightly and
moving it back clockwise, the screw can be loosened even further.
Image 4-2
Image 4-3
