25
8.
Apply a regular pressure while drilling. The drilling performance does not improve by putting
more pressure on the tool. Too much pressure will overload the motor and your annular
cutter will be worn sooner.
A continuous, non-discoloured iron swarf is a sign of correct drilling speed and a well-
cooled, sharp cutter. Let the cutter do the job and give it time to cut the metal!!!
9.
Adjust the oil supply when necessary
9.
Apply less pressure when the drill cuts through the material. The slug will be pushed out of
the cutter by the pilot pin.
10.
Move the ratchet feed handle back until the output shaft is in its highest position and switch
off the motor unit
11.
Remove the burrs, metal chips and clean the cutter and surface without getting injuries.
13.
To remove the annular cutter, hold the cutter while turning the lock ring in counterclockwise
direction, and pull down the cutter.
After drilling the cutter can be hot, resulting in a tighter fitment inside the output shaft. If
this makes the cutter hard to remove, wait a few minutes for the cutter to cool down and try
again.
PROTECT YOUR HANDS FROM THE SHARP CUTTER!
Caution: The metal piece drilled out can be sharp and very hot!!
Summary of Contents for ECO.36
Page 32: ...32 8 Exploded view spare part list 8 1 Exploded views...
Page 33: ...33...
Page 34: ...34...
Page 36: ...36 8 3 Wiring diagrams...
