5
2.
Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair,
clothing, and gloves away from moving parts. Loose clothes, jewelry, or long hair can be
caught in moving parts.
3.
Avoid accidental starting. Be sure switch is off before plugging in. Carrying magnetic drilling
machines with your finger on the switch or plugging in magnetic drilling machines that have
the switch on invites accidents.
4.
Never place hands, fingers, gloves or clothing near cutting area or rotating machine parts.
5.
Remove adjusting keys or switches before turning the machine on. A wrench or a key that is
left attached to a rotating part of the machine may result in personal injury.
6.
Do not overreach. Keep proper footing and balance at all times. Proper footing and balance
enables better control of the magnetic drilling machine in unexpected situations.
7.
Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes, hard
hat, or hearing protection must be used for appropriate conditions.
8.
Always use supplied safety chain during any work on non-horizontal components. Mounting
can release.
MACHINE USE AND CARE
1.
When using the machine on non-horizontal surfaces, you must use cutting paste. Do not use
oil because the oil can drip into the motor unit
2.
During machine operations, the annular cutter must be cooled and lubricated with good
quality cutting or lubrication oil. Remove the slug from the annular cutter after each hole.
Caution, the slug may be hot!
3.
Use clamps or other practical way to secure and support the work piece to a stable platform.
Holding the work by hand or against your body is unstable and may lead to loss of control.
4.
Do not use machine if switch does not turn it on or off. Any tool that cannot be controlled
with the switch is dangerous and must be repaired.
5.
Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing the tool. Such preventive safety measures reduce the risk of starting
the tool accidentally.
6.
Store idle magnetic drilling machines out of reach of children and other untrained persons.
Tools are dangerous in the hands of untrained users.
7.
Maintain machines with care. Keep cutting tools sharp and clean. Properly maintained tools,
with sharp cutting edges are less likely to bind and are easier to control.
8.
Check for misalignment or binding of moving parts, breakage of parts, and any other
condition that may affect the machine operation. If damaged, have the tool serviced before
using. Many accidents are caused by poorly maintained tools.
9.
Use only accessories that are recommended by Euroboor for your model. Accessories that
may be suitable for one machine, may become hazardous when used on another machine.
SERVICE
Tool service must be performed only by qualified repair personnel. Service or maintenance
performed by unqualified personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts. Follow instructions in the
maintenance section of this manual. Use of unauthorized parts or failure to follow
maintenance instructions may create a risk of electric shock or injury.
When using this machine, you MUST wear ear and eye protection.
Summary of Contents for ECO.36
Page 32: ...32 8 Exploded view spare part list 8 1 Exploded views...
Page 33: ...33...
Page 34: ...34...
Page 36: ...36 8 3 Wiring diagrams...
