ISSUE 1/Original version/OCT 2013
10
10
DESCRIPTION (fig. 1)
WARNING: Never modify the power tool or any part of it. Damage or personal injury could
result.
1.
Safety Guard
2.
Feed handle
3.
Cooling system tank
4.
Magnetic stand
5.
Magnet switch
6.
Motor switch
INTENDED USE
This magnetic drilling machine is intended for commercial use as a drilling machine for drilling
materials with a magnetizable surface using annular cutters and twist drills, and for tapping,
countersinking and reaming in a weather-protected environment using the application tools and
accessories recommended by EUROBOOR.
The magnetic drilling machine can be used horizontally, vertically or overhead.
INSTRUCTIONS FOR PUTTING INTO OPERATION
Please make sure that the contacting surface for the magnet is level, clean and rust-free.
Remove any varnish or primer. When working on materials that are not magnetizable, suitable
fixation devices, obtainable as accessories from EUROBOOR, e. g. suction plate, vacuum plate or
pipe-drilling device must be used.
When working on steel materials with a material thickness of less than 12 mm, the workpiece must
be reinforced with an additional steel plate in order to guarantee the magnetic holding power.
Check the machine for possible damage; Before using the machine, you must carefully check
protective devices or slightly damaged components to ensure they are operating perfectly and as
intended.
Check that moving are in perfect working order and do not jam and check whether parts are
damaged. All parts must be correctly installed and fulfill all conditions necessary to ensure perfect
operation of the machine.
Damaged protective devices and parts must be repaired or replaced according to specifications by
EUROBOOR of any authorized EUROBOOR dealer.
DO NOT
use under wet conditions or in presence of flammable liquids or gases. This magnetic drilling
machine is a professional power tool.
DO NOT
let children come into contact with the machine. Supervision is required when
inexperienced operators use this machine.
ELECTRICAL SAFETY
The electric motor has been designed for one voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your EUROBOOR MAGNETIC DRILLING MACHINE is designed in class I (grounded) according to
EN 61029-1. Earth wire is required.
If the supply cord is damaged, it must be replaced by a specially prepared cord available through the
EUROBOOR service organization.
