12
9880021100-CU 30P VERONA PRO 040413040413
B. Place the Anti-Tip Bracket 8 5/8” for this Range from the marked “EDGE”
toward centre of opening and against the back wall with a first hole height
of 1 ¾” plus “A” (distance between side wall bottom edge and floor after
range levelling) as shown in figure 14.
C. Use the bracket as a template and mark the required holes, as shown in
figure 14, for the type of construction you will be using.
STEP 2 – Anti-Tip Bracket Installation
Locate the centre of the two holes to be drilled on the wall. Drill a 1/8” pilot
hole in the centre of each hole. (A nail or awl may be used if a drill is not
available). On Wood Construction Wall secure the Anti-Tip bracket to the wall
with the two 3/8” x 1 ½” self-drilling screws provided, and on Cement or
Concrete Construction Wall secure the Anti-Tip bracket to the wall by drilling
two holes with a 4/8” drilling bit and using the two 3/8” x 1 ½” wall plugs with
screw.
NOTE:
Be aware of not drilling the wall hole in proximity of steel pipes or
other components inside the wall that may be damaged. As shown in figure
14 you have two slots in the rear cover to choose from. Also, use a minimum
of 2 screws to install bracket to the wall.
STEP 3 – Range Installation
A. Align the range to its designated location and slide it back into position.
Make sure that the Anti-Tip bracket plate is fully inserted into the range
rear cover slot and above the lower frame plate.
B. For Safety Considerations as well as optimum performance adjust the
range so it is level. This may be checked by placing a spirit level or a large
pan of water on the rangetop or on the oven rack. If an adjustment is
required on free standing, pull the range forward, tip the range and rotate
the levelling feet as required. Slide-in ranges require total removal from
cabinet before an adjustment can be made.
C. To check the range for proper installation of the anti-tip bracket: Remove
lower storage drawer, by pulling downward the lever A on the right hand
side and pulling upward the lever B on the left hand side, while pulling
both levers pull out the drawer or in case that a lower storage drawer is
not supplied remove the lower foot cover by lifting it up and pulling. Use a
flashlight and look beneath lower frame plate and verify that the anti-tip
device horizontal side is properly engaged in the rear cover slot and just
above the lower frame plate.
Summary of Contents for verona pro VEFSGG30
Page 22: ...22 9880021100 CU 30P VERONA PRO 040413040413 Fig n 11 Fig n 12 ...
Page 23: ...23 9880021100 CU 30P VERONA PRO 040413040413 Fig n 13 Fig n 14 ...
Page 24: ...24 9880021100 CU 30P VERONA PRO 040413040413 Fig n 15 Fig n 16 ...
Page 25: ...25 9880021100 CU 30P VERONA PRO 040413040413 Fig n 17 Fig n 18 A Fig n 18 B Fig n 19 ...
