Confirm your input with "done". Also observe the information in the
following chapters on this.
e) Section / test range
In "Section", specify the measuring set-
tings that you desire for recording of the
measurement.
Now tap the temperature values displayed
at the left of the display under "Section". A
new window is opened. Set the upper val-
ue (maximum; e.g. 22 for the temperature)
and the lower value (minimum; e.g. 20 for
the temperature). Confirm the set values
with "done" – just like all following settings.
The graphical illustration then shows the
limits (22 and 20) as lines to make the actual measured values
and the reading dropping below or rising above them better visible.
Additionally select a scan rate in "Test range" that controls the
frequency of the measured value recording (e.g. 1 minute = one
measured value is saved every minute). The values named as
examples here will save your recording at a scan rate (repetition
of saving of a measured value) of one minute (= 60 measured
values per hour).
You can select the number (max. three) of the adjustable "Sec-
tions" under "Testing the interval settings". Here, you can set dif-
ferent scan rates for the measured values for up to three different
temperature ranges. The lower the interval under "Test range" is
set, the more often will the measured temperature be updated and
saved.
Figure 6
47
Summary of Contents for 1486096
Page 95: ...Afbeelding 4 95 ...
Page 107: ......
