33
2. External sources of interference:
Transmission from the time signal trans-
mitter to your radio-controlled clock with
meteorological station is interrupted.
3. You have entered a time zone value,
which e/– 1 hour.
4. Your radio-controlled clock with meteoro-
logical station operates at the limit or out
of range of the time signal transmitter
(approx. 1500 km around Frankfurt / Main)
Remedy: The clock can be used also purely
in quartz mode (see 8. Handset).
Outside temperature Connection to the outside sensor cannot be
is not displayed.
established.
Did the sensor fail? Is the battery power too
low? Is it installed out of maximum range?
Outside temperature Connection to the outside sensor cannot be
is not being
established. ”E” stands for ”error” and
displayed. ”E” is
appears in case the radio-controlled clock
being displayed
with meteorological station cannot access
as sensor address. the outside sensor for a period of 16 hours.
Did the sensor fail? Is the battery power too
low? Is the sensor installed out of maximum
range?
Atmospheric
1. Is the value of altitude above sea level
pressure is not
correct?
being displayed.
2. Sensor failed
Inside temperature
Sensor failed
is not being displayed.
Humidity is not
Sensor failed
being displayed.
Battery symbol
Battery energy becomes low, please replace
is displayed
battery soon (see 3.1 Replacement of bat-
tery, radio-controlled clock with meteorologi-
cal station)
Weather forecast
Is the value of altitude above sea level
is often incorrect
correct? An incorrect value of altitude
results in an incorrect weather forecast.
For control and correction:
see 6.3 Setup Settings.
8. Handset
If no DCF reception of the radio-controlled clock is possible (for
causes see 7. Indications of failures), you can still operate your
clock as quartz clock.
For this purpose you have to switch to the so-called ”Handset
mode”.
This is accomplished by removing the clock batteries, waiting at
least 1 minute and inserting the batteries back again while holding
the
PROG
/ SNOOZE key pressed.
Following this procedure, time, date, weekday and language set-
ting appears on the display. The set language symbol is blinking.
Select the language accordingly using the MIN / – or MAX / + keys
(no repeat function). Advance to the next setting using the
SET
/
SYNC key. Enter all relevant settings this way.
After finishing the complete procedure, press the
PROG
/ SNOOZE
key. From now on the clock operates in the quartz mode.
Summary of Contents for 53166
