54
The wind, gust and precipitation alarms are only triggered when the measurement exceeds the preset
maximum. There is no minimum trigger value: "WIND HI" > "Gust HI" > "RATE HI" > "DAY HI".
12. Functions
a) Outdoor sensor
• The outdoor sensor transmits data to the weather station every 16 seconds.
• You may need to resync the measurements with the weather station if the connection is interrupted.
• To resync the outdoor sensor with the weather station, press and hold the
LIGHT/SNOOZE
button (1) on the
weather station for 5 seconds. All saved measurements will be deleted, but existing settings will not be affected.
The number of bars on the synchronisation symbol (
) indicates the number of signals received from the outdoor
sensor. The resync process may take a few minutes. Do not press any buttons during this time. All five bars will be
displayed (
) when five signals have been received.
• If the measurements fail to sync, reset the weather station by removing and reinserting the batteries or power
adapter. Disconnecting the power adapter when no batteries are inserted will clear all settings on the weather
station. Maximum and minimum measurements will also be deleted.
b) Silencing the alarm and using the snooze function
• An alarm tone will be played at the preset alarm time and the bell symbol (
) will start to flash. The alarm will turn
off automatically after two minutes.
• To snooze for ten minutes, press the
LIGHT/SNOOZE
button (1) before the alarm turns off. The snooze symbol (
Z
z
)
will appear on the display and the alarm will go off again after 10 minutes. This cycle will be repeated until you press
another button (not the
LIGHT/SNOOZE
button (1)).
c) Disabling the button lock and using the backlight
• The weather station automatically locks the buttons and turns off the backlight after 15 seconds of inactivity when
the power adapter is not connected.
• Press the
LIGHT/SNOOZE
button (1) to unlock the buttons and turn on the backlight for 15 seconds. You can also
unlock the buttons by connecting the power adapter.
• To adjust the brightness of the backlight when the power adapter is connected, press the
LIGHT/SNOOZE
button (1). There are three settings: bright, medium and off.
d) Viewing the absolute and relative pressure
• Press and hold the
PRESSURE -
button (4) for two seconds to switch between the absolute and relative pressure.
"ABS" indicates absolute pressure and "REL" indicates relative pressure.
• Press the
PRESSURE -
button (4) to display the average pressure. Press the button again to display the average
pressure for the last 12/24/48 and 72 hours. "AVERAGE" will be displayed next to "12Hr", "24Hr", "48Hr" or "72Hr".
• Press the
PRESSURE -
button (4) after the last reading ("72Hr") to go back to the home screen.
