Troubleshooting
7 - 32 Warning Messages
7
message:
Failing Bits: nnnn
description:
The hex number, nnnn, is a map of the bits at the RAM
address that failed the memory test.
solution:
1.
Make sure the expansion memory is seated properly in its
socket(s) (
see Chapter 6:“- Memory Insertion” on
page 6-13
).
2.
Run
Setup
to allow the system to recheck the amount of
memory present, then save the
Setup
information and
reboot.
3.
Turn off the system and remove any DIMMs (
see Chap-
ter 6:“- Memory Removal” on page 6-12
). Restart the
system. If the problem persists, contact your service center.
If the problem disappears, replace the DIMMs one at a
time to identify the defective module. Replace any defec-
tive DIMMs.
message:
Fixed Disk x Failure or Fixed Disk Controller Failure
description:
The hard disk is not working or is not properly configured.
solution:
1.
Check that the HDD is properly attached (
see Chapter
6:“- Hard Disk Insertion” on page 6-6
).
2.
Run
Setup
to make sure the HDD is correctly configured
(
see Chapter 5:“Switching Hard Disks” on page 5-12
).
Summary of Contents for 4200 San Marino
