1
6
INSTRUCTIONS FOR USE IB 40 CLASSIC
After ironing
- Leave the board on for 10 minutes to dry the cover and remove any possible
condensed water from the board.
- Turn off the ironing board using the power on/off switch.
- Remove the plug from the socket.
- Let the equipment cool completely.
- Remove the iron cord support.
- Place the iron on the iron rest pad.
- Unplug the iron/steam generator from the auxillary socket and remove it from the
board.
- Fold the shelf back over the ironing surface.
- Wind the power supply cord on to the cord winder lugs beneath the board.
- Hold the board leg with your foot to stop it skidding.
- Operate the height adjustment lever and close the board.
Note:
do not entangle the power cord
- Store the closed board in a vertical position with the folded shelf end towards the
floor. Always ensure that the board does not skid and tilt. Store the equipment in a
dry place and out of reach of the children.
MAINTENANCE IB40 CLASSIC
Changing the cover of your IB 40
guarantee the perfect operation of the product we recommend that you use only
original ironing board covers.
Meatalised heat reflective covers and covers with thick lining are not suitable for this
equipment and may cause overheating of the suction motor.
Original covers and other accessories are avalable from authorised technical service
centres.
Warning:
In case of failure, of faulty equipment or if damage due to falling over is suspected,
immediately remove the plug from the socket. Repairs should be exclusively per-
formed at the authorised Service Centre. Repairs performed by unskilled personnel
may cause serious dangers for users. Responsibility is declined for damages caused
by repairs performed by unskilled personnel.
In these cases the warranty right is also cancelled.
WARNING:
all parts can be supplied, with the same functionality and interchangeability,
with treatments and/or different colors from the original.
With continuous use, the cover which is fitted with a drawstring is subject to wear and
should be replaced regularly.
For safety reasons (heated board surface) and to
