00054564, Version 1.3
24/27
Other mode
In this mode there are 3 sub-menus to choose from. Please press the SET UP button to reach the selection,
as appropriate.
At
and
via the UP or DOWN buttons, you can decide if the display should always be on, or
if it should turn off after 60 seconds of inactivity.
At
and
via the UP or DOWN buttons, you can decide if the display should display normally,
or if it should display upside-down.
At
you can reset to ex works setting. Please push the UP and DOWN buttons at the same time. The
display shows
and the color switching programs begins to run.
DMX-mode
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Addressing
Press the MODE button to select the DMX mode and the display shows
~
.
You can select the desired addresses via the UP or DOWN buttons.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the control display flashes. This function is only available if the display
mode under Other was set to
.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective.
- the cable or connector is defective or the signal cable is not well connected.
DMX Channel Selection: Choosing a DMX Channel Mode
After having set the desired address, you can now choose a DMX Channel Mode. (3CH/4CH/5CH/6CH).
Please press the SET UP button until the display shows
/
/
/
.
Set the desired mode via the UP or DOWN buttons.
DMX-protocol
3-channel mode:
In this mode, the last possible starting address is 510.
CH
Value
Function
1 000~255 Red (0 – 100%
)
2 000~255 Green (0 – 100%
)
3 000~255 Blue (0 – 100%
)
4-channel mode:
In this mode, the last possible starting address is 509.
CH
Value
Function
1 000~255 Red (0 – 100%
)
2 000~255 Green (0 – 100%
)
3 000~255 Blue (0 – 100%
)
4 000~255 Dimmer (0 – 100%
)
