24
•
EN
TEST RUN
Step 1
Install the Space Ball, connect a DMX controller and switch on the hoist. The winch moves to a defined starting
position.
Step 2
Step 3
Indicates DMX address
Flashes in case of missing signal
To test the DMX connection, pull up the channel
fader 6 and observe the Space Ball’s
movement, then move the fader back down to 0.
The Space Ball should move up
and down.
Set channel fader 8 to a value between 240
and 245 and reset the winch. In case of any
malfunction, check the DMX connection.
Correct starting position.
Wrong starting position.
Set value
to 20.
Reset with
240-245.
Lights up after power on
