51785875_V_1_2.DOC
25/52
Controlling:
After having addressed all TC-5, you may now start operating these via your lighting controller.
Note:
After switching on, the TC-5 will automatically detect whether DMX 512 data is received or not. If the data is
received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights up
permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the TC-5.
-
the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Control channel 1 - Colour-wheel
Linear colour change following the movement of the slider. In this way you can stop the colour-wheel in any
position.
Decimal Hexad. Percentage S/F
Feature
0 9
00 09
0% 4%
S Closed
10 20
0A 14
4% 8%
S White
21 31
15 1F
8% 12%
S Green
32 41
20 29
13% 16%
S Red
42 52
2A 34
16% 20%
S Cyan
53 63
35 3F
21% 25%
S Bright green
64 73
40 49
25% 29%
S Magenta
74 84
4A 54
29% 33%
S Bright blue
85 95
55 5F
33% 37%
S Yellow
96 105
60 69
38% 41%
S Green
106 116 6A 74
42% 45%
S Deep rose
117 128
75 80
46% 50%
S Blue
129 190
81 BE
51% 75%
S Scroll
191 193 BF C1
75% 76%
S Sound-controlled
194 223 C2 DF
76% 87%
F Forwards rainbow effect with decreasing speed
224 225 E0 E1
88% 88%
S No rotation
226 255 E2 FF
89% 100%
F Backwards rainbow effect with increasing speed
Control channel 2 - Dimmer intensity
Decimal Hexad. Percentage S/F
Feature
0 255
00 FF
0% 100%
F Gradual adjustment of the dimmer intensity from 0 to 100 %
