EN
37
burning gas or other fuels.
L) There is a risk of
fi
re if cleaning is
not carried out in accordance with
the instructions.
This appliance conforms to the Europe-
an Directive EC/2002/96, Waste Electri-
cal and Electronic Equipment (WEEE).
By making sure that this appliance is dis-
posed of in a suitable manner, the user
is helping to prevent potential damage to
the environment or to public health.
The symbol on the product or on
the accompanying paperwork in-
dicates that the appliance should
not be treated as domestic waste, but
should be delivered to a suitable elec-
tric and electronic appliance recycling
collection point. Follow local guidelines
when disposing of waste. For more in-
formation on the treatment, re-use and
recycling of this product, please contact
your local authority, domestic waste col-
lection service or the shop where the ap-
pliance was purchased.
INSTALLATION
INSTRUCTIONS
• • Assembly and electrical connec-
tions must be carried out by spe-
cialised personnel.
• • Wear protective gloves before
proceeding with the installation.
• • Electric Connection:
– The appliance has been manufac-
tured as a class II, therefore no earth
cable is necessary. The plug must be
easily accessible after the installa-
tion of the appliance. If the appliance
is equipped with power cord without
plug, a suitably dimensioned omnipo-
lar switch with 3 mm minimum open-
ing between contacts must be
fi
tted
between the appliance and the elec-
tricity supply in compliance with the
load and current regulations.
– The connection to the mains is carried
out as follows:
BROWN =
L
line
BLUE =
N
neutral.
• If the hob is electric, gas, or induction,
the minimum distance between the
same and the lower part of the hood
must be at least
65 cm
. If the instruc-
tions for installation of the gas hob
specify a distance greater than the
one indicated, this must be taken into
account. If a connection tube com-
posed of two parts is used, the upper
part must be placed outside the lower
part. Do not connect the cooker hood
exhaust to the same conductor used
to circulate hot air or for evacuating
fumes from other appliances generat-
ed by other than an electrical source.
Before proceeding with the assembly
operations, remove the anti-grease
fi
lter(s) (Fig.4) so that the unit is easi-
er to handle.
– In the case of assembly of the appli-
ance in the suction version prepare
the hole for evacuation of the air.
• We recommend the use of an air ex-
haust tube which has the same diam-
eter as the air exhaust outlet hole. If a
pipe with a smaller diameter is used,
the e
ffi
ciency of the product may be
reduced and its operation may be-
come noisier.
• If your appliance has been designed
for use in habitations supplied with
