10
TROUBLESHOOTING
Fault
Cause
Solution
Light on, but
motor does not
work
The blades are blocked.
Check the blades.
The capacitor is damaged.
Replace capacitor.
The motor is damaged.
Replace motor.
The internal wiring of motor is cut off/ disconnected. An
unpleasant smell may be produced.
Replace motor.
Both light and
motor do not
work
Apart from the above mentioned, check the following:
Light damaged.
Replace lights.
Power cord loose.
Connect the wires as the electric diagram.
Oil leakage
Outlet and the air ventilation entrance are not tightly
sealed.
Take down the outlet and seal with glue.
Vibration
The blade, if damaged, can cause vibrating.
Replace the blade.
The motor is not tightly fastened.
Fasten the motor tightly.
The cooker hood is not tightly fixed.
Fixed the cooker hood tightly.
Insufficient
suction
The distance between the cooker hood and the cooker
top is too large.
Readjust the distance.
Too much ventilation from open doors or windows.
Choose a new place to install the appliance
or close some doors / windows.
The machine
inclines
The fixing screws are not tight enough.
Tighten the fixing screw and make it
horizontal.
The hanging screws are not tight enough
Tighten the hanging screw and make it
horizontal.
ELECTRICAL DIAGRAM
Electrical diagram see label on main body of the actual product.
The air flow parameter is tested under conditions of 120V 60Hz ( 230V 50Hz ) when the voltage is 110-127V~ 6 0Hz ( 220-
240V ~ 50/60Hz ) and without carbon filters.
e
g
a
tl
o
V
Rated Power
Lighting Power
Motor Power
Diameter of air tube
4
w
o
lf
r
i
A
e
s
i
o
N
220-240V 50Hz
~
1.5W x 2
150mm
3
/h
6
110W
113W
7 dB(A)
00m
