INSTRUCTIONS FOR USE
10
- GB
−
press the (+) button; the display shows “OF” and the “…key…” symbol.
At this point the safety lock is activated and after about 5 seconds the display
shows the current time and the “…key…” symbol.
Deactivating the lock:
−
press the (
-
) and (
+
) buttons at the same time for about 8 seconds
−
the display shows “OF”; release the buttons
−
press the (+) button; the display shows “ON”
At this point the safety lock is deactivated and after about 5 seconds the display
shows the current time.
Electronic touch programmer
Setting the current time
When the power is connected, “12:00” and the
symbol flash on the display. By touching
any one of the controls (+, - or
SELECT
), the
symbol
MAN
appears and it is possible to set
the time, pressing the
-
or
+
buttons
within 5
seconds.
Subsequent adjustments of the time can be
made by repeatedly touching the
SELECT
control until the symbol flashes and
adjusting the time as described above.
General notes
−
Setting the current time whilst an automatic programme is active will cancel the
programme.
−
The loudness of the buzzer can be modified by repeatedly touching the
SELECT
control until the level set appears (
L1
,
L2
or
L3
) and pressing
+
or
-
.
−
If not deactivated, the buzzer stops automatically after about 7 minutes.
−
The maximum programming time is 23 hours 59 minutes.
−
If there is a power cut, all the programmed settings are cancelled; when power
returns, the display flashes, showing 12:00. To restore the functioning of the
appliance, reset the current time and any programme.
Timer buzzer
To use it as a simple timer, touch the
SELECT
control repeatedly until the
symbol flashes, set the time desired, pressing
+
or
-,
after about 5 seconds the
symbol stops flashing and the time starts to decrease; to modify the time set or
zero it, press
+
or
-
.
When the time is finished, touch any one of the controls to deactivate the buzzer.
The maximum time that can be set is 99 minutes.
SELECT