16
Installation
WARNING
Do not put the power plug into the wall socket before the device is correctly
assembled and in the right place.
Do not use an extension cable, as this can cause overheating and fire. If using
an extension cable is unavoidable, make sure it is undamaged and earthed.
Use an extension cable with a minimum power of 2100 Watt. Always unwind
the extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.
1.
Place the device with a minimum distance of:
•
50 cm to a nonflammable ceiling or roof;
•
100 cm to a flammable ceiling or roof;
•
50 cm to the side walls.
Take the minimum distance into consideration
when adjusting the height (Figure 9).
2.
Place the device on a solid, flat and horizontal
surface. The base should be in contact with
the ground over the entire surface.
3.
Do not place the device immediately below a
socket outlet.
Figure 9
4.
Make sure switch I (Figure 10, pos. 3) and
switch II (Figure 10, pos.2) are both in the
OFF position.
5.
Place the power plug (Figure 10, pos. 1) in an
earthed wall socket that is easily accessible.
Use an earthed wall socket with a minimum
power of 2100 Watt.
Figure 10
