17
CONTROL PANEL
1. ON/OFF button
2.
‘Humidity up’ button
3.
‘Humidity down’ button
4. Humidity display
5.
‘ON’ light
6. Watertank full (only LO50)
7. Defrosting light
8. Fan
9. Hour meter
You switch the device on and off with the ON/OFF button.
Every time you press the
buttons ‘humidity up or ‘humidity down, you set the desired air
humidity level1% higher or lower. If you depress the button for longer than 1.5 seconds, the
set humidity will increase/decrease at a rate of 5 points per second.
The devices have a
‘ventilator’ signal light that comes on when the internal ventilator is
working. This always works while the device is operating, unless it is defrosting. The All
devices also have an hour counter that counts the total number of hours your device has
been operating (in units of 10 minutes).
STARTING AND OPERATING
Check that the socket, to which you are connecting the dehumidifier, provides the voltage
as indicated on the specification plate: 220/240V-50Hz.
L070 and LO120: Check that the drainage hose is correctly connected and is able to drain
properly into the appropriate waste outlet.
Insert the plug into the socket; the device will beep.
Press the ON/OFF button. The ON light will come on and the display will show the factory
setting for humidity: 60%.
After three seconds, the display will show the actual air humidity; this will remain on the
display while the device is on.
Press
on the ‘humidity up or 'humidity down button in order to set the desired level. If the set
humidity is over 3% lower than the actual humidity level, the device will start to work and
continue until the actual level is 3% lower than the set level. The device will then switch off.
If the air humidity is set to less than 30%, the device will continuously dehumidify. The
display will show "CO”.
