12
26.
Only use the fireplace for its intended purpose and as stipulated in this instruction
booklet.
Failing to adhere to instructions 24, 25 and 26 could lead to damage, fire and/or personal
injury. This will invalidate the guarantee and the supplier, importer and/or manufacturer will
take no responsibility for the consequences!
DESCRIPTION
The WOODLAND 2000 is a nostalgic fire with an internal heating element and a ventilator,
which blows the heat out of the front of the hearth. Normally the fire is positioned against a
wall.
The fire comes with an instruction booklet that must also be supplied on resale.
INSTALLATION AND CONNECTION
Remove the packaging materials and keep out of the reach of children. After removing
packaging, check device for damage or any evidence that may point to a defect/failure.
If in doubt, do not use the device but refer to your supplier for checks/repairs.
Generally the fire will be placed against a wall.
Place the heater on a sturdy, flat surface. The substrate must be heat-resistant. The
aspiration grilles are located on the bottom, in the wood compartment; make sure they
are never blocked!
Choose a suitable location for the fireplace, at least one metre from all obstructions,
walls and flammable materials (see safety instructions) and in the vicinity of a 10 Amp
(at least) fused,
earthed
electrical socket (protected by a 30 mA earth leakage circuit
breaker).
OPERATING
Check that the details on the data plate correspond to those of the electrical supply
which you wish to use for the fireplace. Connect the plug to an earthed power outlet.
To prevent the circuit overloading, check that no other appliances are connected to the
same group.
The control switches are located behind the metal panel on the front of the heater. Pull
out the panel and you will find 4 control switches. Check that the switches are off: top
depressed. See illustration.
Switch 1 (O/I):
Main switch
Switch 2 ( )
:
ON/OFF switch
Switch 3 (I):
Heat at 1000W (half capacity)
Switch 4
(II):
Heat at 1000W (half capacity)
First press the main switch (O/I); the device is now in the standby mode and can be
operated with buttons 2, 3 & 4.
