38
Operating
Check that the details on the data plate correspond to those of the electrical
supply which you wish to use for the fireplace. Do not use the same connection
for any other group
Install two AAA-1,5V batteries in the remote control.
Check whether the main switch is set to OFF (O is pushed in)
Now insert the plug into the grounded socket.
Push the main switch to ON (I is pushed in). The fireplace is now on stand-by
and the light is switched on at the display
.
You can now further operate the fireplace with the remote control or with the
buttons on the fireplace itself.
Push-button operation:
If you don't use the remote control, you can press the relevant buttons on the
control panel, manually set it to 3 positions; the corresponding lights will turn on.
-
I/O : flame effect only
-
I/O + 1000W : flame display and heating at 1000W
-
I/O + 2000W : flame display and heating at 2000 Watt
By pressing the I/O button longer, you initiate the dimmer function; the light
intensity will increase or decrease with every tweet. Release the button when you
have achieved the desired intensity
Attention! The thermostat cannot be set manually, only with the remote control.
The thermostat is standard set to 20°C.
Remote control:
Press on the ON/OFF button to switch on the stove.
Now set the desired temperature. The temperature & timer setting will usually
show the ambient temperature. By pressing on the + or - button, you see the
set temperature flashing for a short time and by pressing the + or - buttons,
you can adjust the temperature (from 15 to 30°C). After a few seconds, the
display switches back to the ambient temperature and the newly desired
temperature is set. The temperature is standard set to 20°C.
Now you can start operating the stove by pressing the button to 1000W (half
output) or 2000W (full output). When the set temperature is above the ambient
temperature, the stove will start to heat (1000W, 2000W). The corresponding
lights on the display are turned on (1000W-1 star, 2000W-2 stars).
If you press the
button, the window detector will start. The corresponding
lights on the display are turned on (
).
The thermostat will switch off the stove as soon as the stove reaches the
desired temperature and it will switch it on again if the ambient temperature
drops.
By pressing the ‘dimmer’ button (there are 5 positions), you can intensity or
decrease the flame effect of the stove.
Summary of Contents for Malmo 363463
Page 2: ...2 ...
Page 107: ...107 ...
Page 108: ...108 EUROM Kokosstraat 20 8281 JC Genemuiden info eurom nl www eurom nl ...
