28
Storing the humidifier
Clean the air humidifier as set out above. Allow to dry thoroughly.
We recommend carefully cleaning the humidifier before storing it. Ensure that all parts are
clean and dry prior to storing the device. Do not leave water in the lower housing. Water that
remains in the humidifier may result in mineral deposits and promotes the growth of
undesired micro-organisms.
Store in original packaging if you have it.
Place it straight up in a cool, dry place. Prevent excess heat!
Replacing the vaporisation element
Use only original supplied evaporation mat
1. Switch the device off and remove the plug from the socket.
2. Remove the main housing from the bottom housing / water tank.
3. Remove the vaporisation element.
4. Insert a new vaporisation element.
5. Return the main housing onto the bottom housing / water tank.
Ensure that both housings fit correctly onto each other.
6. To reset the built-in hour counter, press the ON/OFF button for 3
seconds, until you hear the sound signal.
Troubleshooting
If your air humidifier is not working properly, check for the following issues:
Problem:
Possible cause:
Solution:
The device does not work
Control button at OFF
No electricity
Is the water tank
sufficiently full and does
the main housing fit the
bottom housing correctly?
Switch On
Plug in socket
Is the fuse/earth leakage
circuit breaker engaged
Fill the water tank and
place the main housing
correctly onto the bottom
housing.
No power failure?
The device is giving an
unpleasant odour
Dirty water or water that
has been in the device to
long
Replace the water and
clean the tank
The humidity level does not or
hardly change
Vaporisation element is
installed incorrectly.
Vaporisation element is
dirty.
Too much ventilation in the
room
The room is too large for
the apparatus.
Install the vaporisation
element correctly.
Clean or replace the
vaporisation element.
Compare the dimensions
of the room with the
recommended
dimensions.
If your problem is not resolved by the tips outlined above, please consult your supplier or a
recognised servicing point. Never attempt to carry out repairs yourself! This will invalidate the
guarantee and no liability will be taken by the supplier, manufacturer or importer!.
.
