GB
22
•
Fluid can escape from the battery when used
incorrectly. Battery fluid may result in skin irrita-
tions and burns. Avoid contact! In the event of
accidental contact, rinse thoroughly with water.
Immediately seek the aid of a physician in the
event of eye contact.
Device-specific safety instructions
•
Do not use adapters for extension cables.
•
The unit must be assembled on an even, horizon-
tal surface with space surrounding it.
•
Only operate the unit in well ventilated rooms.
•
Never feed objects through the ventilation slots
into the unit. Risk to life!
•
The unit may not be covered. This causes a risk
of fire.
•
Never set up the unit next to easily flammable
objects. Always maintenance a minimum distance
of 1 metre.
•
Make sure that flammable materials or sub-
stances capable of exploding are kept out of the
vicinity.
•
The unit may not be operated in rooms with bath
tubs, showers or swimming pools or in the vicinity
of sinks or water installations.
•
The unit heats up when in operation. Risk of
injury!
•
The unit may not be operated outside.
•
This appliance can be used by children aged from
8 years and above and by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and if they understand
the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
•
Children of less than 3 years should be kept away
unless continuously supervised.
•
Children aged from 3 years and less than 8 years
shall only switch on/off the appliance provided
that it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
•
CAUTION! Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and vul-
nerable people are present.
•
Symbols affixed to your unit may not be removed
or covered. Information on the unit that is no
longer legible must be replaced immediately.
Before putting the unit into operation, read
and observe the instructions for use.
In order to prevent overheating, do not cov-
er the heater!
An overview of your unit
Note:
The actual appearance of your prod-
uct may differ from the illustrations.
1. Spray hole
2. Display panel
3. Net
4. Front panel
5. Top panel
6. Back panel
7. Back cover
8. Drain cover
9. Control panel
10. Remote control
11. Air cooler
12. Low heat
13. High heat
14. Humidifier
15. Timer
16. Temperature
Assembly
Base setting:
– Align the four screw holes of the chassis with the
screw holes of the main body, and lock the main
body and the chassis with four self-tapping
screws.
Fill water into the water tank:
– Open the back cover and take off the water tank.
– Fill the water tank with clean water lower than 40
degree (pure water is recommended)
– Put back the water tank and the back cover.
Operation
Check before switching on!
DANGER! Risk of injury!
The unit may
only be put into operation if no defects are
found when it is checked. If a part is defec-
tive, it must be replaced before the machine
is used again.
Check to make sure the unit is in a safe operating
condition:
– Check to make sure there are no visible defects.
– Check to ensure that all switches have been set
to
[0]
, before plugging the unit into the power
socket.
Operating the unit
– Before inserting the plug into an electrical outlet,
make sure that the electrical supply in your area
matches that on the rating label on the unit.
– Power on: Place the unit on a stable floor and
insert the plug into the socket. Turn on the power
switch on the back of the unit.
[I]
means on,
[0]
means off;
– When the unit is turned on, the unit would be in
standby mode, the display shows ambient tem-
perature, and the
[°C]
light would be on. Press
