8
Instructions
Control panel or remote control operation
For your convenience, the fan can be operated from the control panel at the
front of the unit, or with the remote control. The buttons on the control panel
operate the same functions as the remote control, except for setting the
timer from the control panel, which is slightly different and explained in the
instructions below.
When using the remote control, point it towards the LED display at the front
of the fan and ensure that nothing is obstructing the path of the signal.
Handle the remote control carefully; do not drop or throw it.
Using the fan
• Place the fully assembled pedestal fan on a dry, level and stable surface,
taking into consideration all relevant safety advice from the previous pages.
• Insert the plug into an appropriate electrical socket and switch on power at
the outlet. The fan will enter standby mode.
• Press the POWER button to power on. The fan will start operation in default
mode (medium speed). Press the button again to set the fan to standby.
• Press the SPEED button to select the fan speed from low, medium and high.
• Press the SWING button to start oscillation for widespread air distribution.
Press the button once more to stop oscillation.
• To set the
timer
with the
remote control
, press the TIMER button. Then set
the off-time in 1 hour increments up to a maximum of 18 hours.
• To set the
timer
on the
control panel
, press the SWING button and hold it
for 3 seconds until the timer indicator on the display screen starts flashing.
Then set the off-time as described above. The selected timer setting will
flash 3 times on the panel and then turn back to show the selected speed.
• After the timer runs out, the fan will automatically shut off.
• Unplug the fan when not in use.
SWING
SPEED
POWER
POWER
SWING
SPEED
TIMER
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
