REV.0.02_COD.500201_A4
PAG. 22
3.6.4 Warning
•
For the maximum amount of product which can be used for washing cycle, follow the instructions for the product
you are using.
•
The quantity of supplied can be adjusted by following the directions given in chapter 12 – Chemical calibration.
•
To ensure the efficiency of the chemical dosing system it is recommended to perform the calibration procedure
every 6 months.
•
To ensure the efficiency of the dispenser pumps for chemical products it is important to service them regularly as
described in chapter 18.
•
Use liquid chemical products only machine cannot function with powder detergent.
•
For the dispose of the chemical detergent and his tank follow the instruction indicated on the technical and safety
data sheet provided by the manufacturer.
•
Check that type of chemical product is suitable for the specific washing program used.
•
Don’t place the chemical tank on the machine.
ATTENTION
Before undertaking any sort of special maintenance or movement of machine, empty tanks and
chemical dosing circuit from the chemical. It is advised to execute a treatment cycle without
chemical.
This procedure must be carried out in order to prevent contact of the chemical product with
body parts and machine components that can be damage.
3.6.5 Information
•
The machine has been validated in accordance with the provisions of Standard UNI EN ISO 15883.
•
The type test was carried out using the most widely known chemical products on the market, concerning the type of
chemical products, the concentrations and the cycle parameters used you can ask the Manufacturer for details.
3.7 Connecting the discharge pipe
•
The discharge pipe connection should be checked carefully.
•
Use a discharge pipe suitable for organic and chemical materials and hot liquids.
•
Caution: if the discharge pipe is clogged take great care when processing the water and avoid contact with
hands, eyes, etc. In the case of contact rinse the parts concerned with plenty of water.
•
These models are equipped with one pipe connected to drain with diameter 22 mm.
CONNECTING DRAIN PIPE:
The drain pipe is connected to the sewer network in the following manner:
•
Identify the drain pipe and relative fittings, and assemble them.
Make sure the seal gasket is installed correctly.
•
Identify the drain manifold and connect the hose via the union and ring nut. Tighten the ring nut firmly.
•
Insert the drain hose and clamp it in place.
•
Insert the other end of the hose into the drain unit, fitting it properly and locking it in position.
IT IS NECESSARY TO FOLLOW THESE INSTRUCTIONS FOR DRAIN CONNECTION
•
Drain pipe must be connected by using a clamp.
•
Drain pipe must not present angles or irregular curving in its course.
•
Drain point must be placed at the same height of the machine drain point or on the floor.
FOLLOW CAREFULLY THESE INSTRUCTIONS AS A WRONG DRAIN CONNECTION CAN CAUSE THE BLOCK OF
MACHINE.
•
Diameter of drain main must be of at least 25 mm.
•
Avoid drain pipe extension.
