Hub van Doorneweg 8 • 2171 KZ Sassenheim – NL •
T
+31(0)252 228850 •
F
+31(0)252 228235 •
E
sales@euronorm.nl •
I
euronormdrives.com
8
9
EURN010000_
002_C
EURN010000_
002_C
6. Wiring diagram
8 / 24
6
6.
.W
Wi
ir
ri
in
ng
g
d
di
ia
ag
gr
ra
am
m
Notes in main circuit wiring
Wiring specifications, please implement wiring in accordance with electrical regulations;
Do not connect AC to the output of frequency converter (U, V, W), otherwise the frequency inverter will be damaged;
Power supply wiring, please try to use isolation line and pipeline, and the isolation line or pipeline ends grounded;
Frequency inverter grounding wire cannot be grounded together with welding machine, high-power motor or high current load, please grounding alone;
Grounding
please grounding correctly,grounding resistor less than 10
Ω.
Notes in wiring control circuit
Please separate the control signal line from the main circuit line and other power lines;
To prevent misoperation caused by interference, use twisted or double shielded wires,specification 0.5~2mm²;
Make sure the permissible conditions of each terminal, such as power supply, maximum permissible current, etc;
The terminal wiring requirements, correct selection of accessories, such as: Voltmeter, input power supply, etc;
After completing the wiring, please check it correctly and make sure that it is correct before powering it on.
Notes in main circuit wiring
Wiring specifications, please implement wiring in accordance with electrical regulations;
Do not connect AC to the output of frequency converter (U, V, W), otherwise the frequency inverter will be damaged;
Power supply wiring, please try to use isolation line and pipeline, and the isolation line or pipeline ends grounded;
Frequency inverter grounding wire cannot be grounded together with welding machine, high-power motor or high current
load, please grounding alone;
Grounding please grounding correctly,grounding resistor less than 10Ω.
Notes in wiring control circuit
Please separate the control signal line from the main circuit line and other power lines;
To prevent misoperation caused by interference, use twisted or double shielded wires,specification 0.5~2mm²;
Make sure the permissible conditions of each terminal, such as power supply, maximum permissible current, etc;
The terminal wiring requirements, correct selection of accessories, such as: Voltmeter, input power supply, etc;
After completing the wiring, please check it correctly and make sure that it is correct before powering it on.
