background image

1  

 

7/20/15 

E

UROPEAN 

F

INISHING 

E

QUIPMENT 

C

ORP

901Penhorn Ave, Unit #2 
Secaucus, NJ 07094  
Tel: (201) 210-2247   (888) 460-9292   Fax (201) 210-2549 

 

www.histeam.com

     

sales@histeam.com

  

 
 

 

 

IMPORTANT SAFETY INSTRUCTIONS 

MODEL PND-2500A 

 
 

FOR COMMERCIAL USE ONLY 

 
 

READ ALL INSTRUCTIONS BEFORE USING 

 

SPECIAL SAFETY INSTRUCTIONS  

 

1.

 

RISK OF FIRE – Turn off the vacuum board and iron switches, and unplug the vacuum 
board and iron when finished ironing. 

2.

 

To avoid a circuit overload, do not operate another high voltage appliance on the same 
circuit. 

 

------------------------------- 

 

GENERAL SAFETY INSTRUCTIONS 

 

1.

 

Use vacuum board only for its intended use. 

2.

 

To protect against a risk of electric shock, do not immerse the vacuum board in water 

or other liquids. 

3.

 

The  vacuum  board  should  always  be  turned  “Off”  before  plugging  or  unplugging  from 

outlet.  Never  yank  cord  to  disconnect  from  outlet;  instead,  grasp  plug  and  pull  to 
disconnect. 

4.

 

Do  not  allow  cord  to  touch  hot  surfaces.  Let  vacuum  board  and  iron  cool  completely 

before putting away. 

5.

 

Always disconnect appliance from electrical outlet when not in use. 

6.

 

Do  not  operate  appliance  with  damaged  cord  or  hose,  or  if  the  appliance  has  been 

damaged.                                                                                                              
To  reduce  the  risk  of  electric  shock,  do  not  disassemble  or  attempt  to  repair  the 
appliance. Take it to a qualified service person for examination and repair. Incorrect re-
assembly or repair could cause a risk of fire, electric shock, or injury to persons when 
the appliance is used.  

7.

 

Close supervision is necessary for any appliance being used by or near children. Do not 

leave appliance unattended while connected or while iron is on vacuum board.  

8.

 

Burns could occur from touching hot metal parts, hot water or steam. 

 
 
 
 

SAVE THESE INSTRUCTIONS 

 
 

Summary of Contents for MODEL PND-2500A







Reviews: