Page 19
DV 42 Indoor Gas Fireplace
Installation
Section 7: Installing and Removing the Door
WARNING!
We recommend careful consideration be given to the
effects of elevated mantel temperatures which may
be in excess of product design, for example: candles,
plastic or pictures. This can cause melting, deformation,
discolouration or premature failure of T.V. radio, and other
electronic components.
WARNING!
When covering the upper metal portion of the fireplace,
up to 4" (
as shown,
Figure 24
) with a non-combustible
material, the decorative facing materials may be subject
to temperatures in excess of 250° F. This should be
considered when selecting facing materials.
Removing the Door
The DV 42* doors are removed in a few simple steps. Follow
these below to remove the horizontal access panel, unlatch the
door buckles and, remove the door. Replace in reverse order.
Figure 26a.
Locate the door buckles. (both sides typical)
Door Latch Hook
Door Latch Slot
Hand-hold
Release the door buckles.
Figure 26.
Removing and Installing the Horizontal Access Panel
Figure 26b.
Door Buckle Tool
1
Step 4:
Firmly grasp hand-hold
end of door buckle tool
and place the machined
end in the slot under
door frame, as shown.
Figure 26c.
Step 2:
Step 3:
Step 1:
Remove the horizontal cover
by placing fingers in both
finger holes, then pushing
away from you and lifting
out. Place it aside during
maintenance or cleaning.
Install in reverse order.
Installed Gas
Valve Cover
Finger Holes
The supplied nailing extension must be placed along the top
edge of the fireplace and securely fastened in place to the metal
lintel and combustible wood framing.
Note: The nailing flange extension can be substituted with a
piece of NON-Combustible material of the same size and thermal
characteristics, i.e.; cement board or equivalent.
XW2004
Glass doors on gas fireplaces are
extremely hot
while the fireplace is
on and remain hot even after the
fireplace has been turned off. Safety
screens are available and can reduce
the risks of severe burns. Please
keep children away from the fireplace
at all times.
CAUTION
Do not use ammonia based or abrasive
cleaners on the glass, they will
permanently etch the surface. Use an
approved gas fireplace glass cleaner
such as Kel-Kem or White off.
NOTICE
XW2000
Locate the door buckles.
