Page 20
DV 42 Indoor Gas Fireplace
Installation
Section 8: Installing the Accessories
Section 7: Installing and Removing the Door (cont.)
Figure 27.
Finished glass bead installation.
Installing the Glass Beads and Optional Fire Media
The
DV 42
fireplace is supplied with glass beads. Optional stone
and driftwood fire media are available.
Remove the door and trim as shown previously. Follow these
instructions to ensure all parts are removed or replaced as
required. Once the trim and glass doors are removed place
the glass beads
AROUND
the burner. The glass beads may be
placed on the mesh pilot flame cover but
neither the glass
beads nor the fire media may be placed on the burner itself
(see
Figure 27
, below.)
To install the door, hook the top edge of the door frame into
place. Lower the door into position and follow the previous
steps shown in reverse order.
Installing the Door
2
Step 5:
Ensure the tool is firmly
in the lower end of the
slot, as shown, then pull
toward you.
CAUTION: Hold the tool
securely.
3
Step 6:
Pull hard if necessary
to release the spring
tension. CAUTION: The
latch springs back with
force, hold the tool
securely.
4
Step 7:
Remove the tool from
the latch slot. Ensure
the latches are hanging
freely, the hook end is
released from the bottom
of the door. Repeat all 4
steps for the remaining
latches.
Figure 26d.
Figure 26e.
Figure 26f.
Step 8:
Grasp the door on either side, usually midway and lift
upward, lift the door carefully up and away from the front
of the fireplace.
See
Figures 26g
. Place the door aside in a safe
place while maintenance and/or cleaning is being performed.
Figure 26g.
Removing and Installing the Glass Doors. (both
sides typical)
