Page 4
DV 42 Indoor Gas Fireplace
Installation
Section A: Before you Begin
IMPORTANT MESSAGE: SAVE THESE INSTRUCTIONS
The DV 42* direct vent fireplace must be installed in accordance
with these Instructions. Carefully read all the Instructions in
this manual first. Consult the Local Gas Branch to determine
the need for a permit prior to starting the installation. It is the
responsibility of the installer to ensure this fireplace is installed
in compliance with the manufacturers instructions and all
applicable codes.
BEFORE YOU START:
Installation Checklist
Determine the desired install location of your fireplace.
See Section 1, Dimensions on Page 5, and refer to the
Framing Section 2 for details.
Select the location of your termination and resulting
vent run.
Your selected termination location must be the highest
point in the direct vent installation.
Should it be impossible to meet the venting requirements
laid out in Section 3: Venting, please contact European
Home regarding the use of a European Home Power Vent.
Lay out the vent run; calculating the required elbows
and straight runs of flex or rigid pipe.
Layout electrical requirements. Refer to Section 4: Wiring,
for details.
Refer to Section 5: Installing the gas line, for details on
the gas connection and access.
Refer to local codes and guidelines for installation
requirements.
Installation and repairs should be done by a qualified
contractor and must conform to:
• Installations in Canada must conform to the current
CAN/CGA B-149.1 and .2 Gas Installation Code and local
regulations.
• Installations in the USA must conform to local codes,
or in the absence of local codes to the National Fuel Gas Code,
ANSI Z223.1-1988.
• See Appendix C for installation within the State of
Massachusetts. This fireplace must comply with NFPA-54 Chapter
10.
Installation and repairs should be done by an
authorized gas fireplace service technician. The
appliance should be inspected before use and at
least annually by a professional. More frequesnt
cleaning may be required due to exessive lint from
carpeting, bedding material, ect. It is imperative
that control compartments, burners and circulating
air passageways of the fireplace are kept clean.
NOTICE
XW2016
XW2018
Due to high operating temperatures, this appliance
should be located out of traffic & away from
furniture and draperies.
Children and adults should be alerted to the
hazards of the high surface temperature, which
could cause burns or clothing ignition.
Young children should be carefully supervised
when they are in the same room as the appliance.
Clothing or other flammable materials should not
be placed on or near the appliance.
CAUTION
Irritant
Cutting
Watch your step
Slippery floor
High temperatures
Glass hazard
Danger of suffocation
High voltage
Toxic
Flammable materials
Corrosive
Fork lift trucks
Danger overhead crane
Explosion risk
Oxidising
Danger of death
Biohazard
Laser Radiation
Danger of entrapment
Hot surface
General Warning
Blank
Gas bottles
Watch for
falling objects
Electricity
Danger for cutter
Entrapment hazard
Battery hazard
Rotating parts
Low temperature
Strong magnetic field
Optical radiation
Non ionizing
radiation
Radiation
Hazardous to the
Environment
Danger of harming
your hands
Irritant
Cutting
Watch your step
Slippery floor
High temperatures
Glass hazard
Danger of suffocation
High voltage
Toxic
Flammable materials
Corrosive
Fork lift trucks
Danger overhead crane
Explosion risk
Oxidising
Danger of death
Biohazard
Laser Radiation
Danger of entrapment
Hot surface
General Warning
Blank
Gas bottles
Watch for
falling objects
Electricity
Danger for cutter
Entrapment hazard
Battery hazard
Rotating parts
Low temperature
Strong magnetic field
Optical radiation
Non ionizing
radiation
Radiation
Hazardous to the
Environment
Danger of harming
your hands
Irritant
Cutting
Watch your step
Slippery floor
High temperatures
Glass hazard
Danger of suffocation
High voltage
Toxic
Flammable materials
Corrosive
Fork lift trucks
Danger overhead crane
Explosion risk
Oxidising
Danger of death
Biohazard
Laser Radiation
Danger of entrapment
Hot surface
General Warning
Blank
Gas bottles
Watch for
Electricity
Danger for cutter
Entrapment hazard
Battery hazard
Rotating parts
When this appliance is installed directly
on any combustible material other than
wood flooring, it must be installed on a
metal or wood panel extending the full
width and depth of the appliance or a
fire will occur causing serious injury,
property damage or even death.
XW2020
DANGER
XW2020-When-Installed_[EN].pdf 1 1/24/2011 12:48:53 PM
