Page 15
DV52 Gas Fireplace
rev.101207
Installation
Wiring for the Optional Fan Kit
All
DV 52
fireplaces may be equipped with optional fan kits for circulating heat into
the living space.
Installations in Canada
which employ the fans must be electrically grounded
in accordance with
CSA C22.1
Canadian Electrical Code Part 1 and/or Local Codes.
Installations in the USA
which employ the fans must be grounded in accordance
with local codes or, in the absence of local codes, with the National Electrical Code,
ANSI/NFPA 70-1987.
For more information see the
Fan Kit Installation Guide
included with the fan kit.
NOTE:
If any of the original wire supplied with the appliance is replaced, it must be
replaced with the same type, or its equivalent.
Figure 27.
Wiring schematic for optional fans.
G
L2-WH
L1-BLK
p g
Quick Connect
lu to motor
5/1/60 Supply
G
L1 L2
Removing and Installing the Door
The doors are removed in a few simple steps. Follow the steps below to remove the
horizontal access panel, unlatch the door buckles and remove the door. Replace in
reverse order.
Figure 28a.
Locate the door buckles. (both sides typical)
Figure 28.
Removing and installing the horizontal access panel
Locate the Door Buckles
Step 2:
Step 1:
Remove the horizontal cover by
placing fingers in both finger holes,
then pushing away from you and
lifting out. Place it aside during
maintenance or cleaning.
Install in reverse order.
Finger Hole
Remove the Horizontal Access Pan
el
Door Latch Hook
Door Latch Slot
Hand-hold
Release the Door Buckles
Figure 28b.
Door buckle tool
1
Step 4:
Firmly grasp hand-hold end
of door buckle tool and place
the machined end in the slot
under door frame as shown.
Figure 28c.
Step 3:
Horizontal
Access Panel
