OPERATING the FIREPLACE
J Series Outdoor Gas Fireplace
European
Home
.com
12
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
BEFORE LIGHTING, smell all around the heater area for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor’s phone.
•
Follow the gas supplier’s instructions. If you cannot reach your gas supplier, call the fire department.
LIGHTING INSTRUCTIONS
1.
Push in gas valve knob slightly and turn to “OFF”.
2.
Wait five (5) minutes before attempting to light the burner.
3.
Push the igniter button and hold. You will hear a repeating clicking sound.
4.
Turn gas valve knob to “PILOT” position and push all the way in. The pilot should light. If so,
release the igniter button.
5.
If the flame does not light after 4 seconds, repeat steps 1 through 4. Continue to press the knob
for 60 seconds. Release the knob and it will pop back out.
6.
Turn the valve knob to the “ON” position. If the burner will not stay lit, turn the knob to “OFF”
and call your service technician or gas supplier.
TO TURN OFF GAS
1.
Push in gas control knob slightly and turn to “OFF”.
OFF
PILOT
ON
The Igniter Button (see picture above) takes (1) AAA battery.
To replace, unscrew Igniter Button cap, replace battery, and put cap back on.
