27
JVF-M2 Series Outdoor Gas Fireplace
IGM2S-190417
INDEX
APPENDIX A
STOP! THIS CONVERSION MUST ONLY BE PERFORMED BY A QUALIFIED SERVICE
AGENCY OR PERSON
1. Remove any burner media and clean unit
2. Remove glass capture panels and optional wind guard
(if applicable).
3. Remove frosted glass and clear glass from the light beds,
store safely. Remove antenna on double sided.
4. Snip zip ties on front light for single side and both side
for see-through.
5. Unscrew front light at silver connector to remove light
on single side, both on see-through. Store in safe place.
6. Remove 3 screws holding light reflector under where zip
ties were with a 5/16” wrench. Lift out and store.
7. Remove 3 screws holding in rear reflector with 5/16”
wrench, lift out and store safely.
10. Remove four 3/8” nuts and two #8 screws from the
burners with a 3/8” and 5/16” wrench respectively and remove
the burners.
11. Remove the two natural gas orifices with a 9/16” wrench
and replace with the two propane orifices.
8. Remove the six 3/8” nuts from the burner base.
9. Remove the six #10 screw from the burners. Remove the
perforated pilot shield from the left burner.
