Page 15
Vista 38 ST See-thru Gas Fireplace
rev.110331
Installation
Wiring
Gas Control and Pilot Wiring
Vista 38 ST
Wiring for the
optional
Fan Kit
The
Vista 38 ST
fireplace may be equipped with optional fan kits for circulating heat
into the living space.
Installations in Canada
which employ the fans must be electrically grounded in
accordance with
CSA C22.1
Canadian Electrical Code Part 1 and/or Local Codes.
Installations in the USA
which employ the fans must be grounded in accordance
with local codes or, in the absence of local codes, with the National Electrical Code,
ANSI/NFPA 70-1987.
For more information see the
Fan Kit Installation Guide
included with the fan kit.
NOTE:
If any of the original wire supplied with the appliance is replaced, it must be
replaced with the same type, or its equivalent.
Figure 32.
Wiring schematic for optional fans.
G
L2-WH
L1-BLK
p g
Quick Connect
lu to motor
5/1/60 Supply
G
L1 L2
Vista 38 ST
WARNING!
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etching may cause
premature glass failure.
Do not operate this fireplace without the glass door, or with a broken glass
door.
WARNING!
We recommend careful consideration be given to the effects of elevated
mantel temperatures which may be in excess of product design, for example:
candles, plastic or pictures. This can cause melting, deformation, discoloration
or premature failure of T.V. and radio components.
Figure 31.
Wiring the
Vista 38 ST
remote receiver.
Thermostat Wire
(supplied)
to thermocouple
to thermopile
