Page 18
Vista 38 ST See-thru Gas Fireplace
rev.110331
Operation - Model Vista 38 ST
Vista 38 ST
WARNING:
If you do not follow these instructions exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
•
If you cannot reach your gas supplier, call the Fire Department.
C.
Use only your hand to push in or turn the gas control knob. Never use
tools. If the knob will not push in or turn by hand, don't try to repair it,
call a qualified service technician. Force or attempt to repair may result
in a fire or explosion.
D.
Do not use this appliance if any part has been under water. Immediately
call a qualified service technician to inspect the appliance and to replace
any part of the control system, and any gas control which has been under
water.
A.
This appliance has a pilot which must be lighted by hand. When lighting
the pilot, follow these instructions exactly.
B. BEFORE LIGHTING
smell all around the appliance area for gas. Be sure
to smell next to the floor because some gas is heavier than air and will
settle on the floor.
What To Do If You Smell Gas:
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do not use any phone in your
building.
•
Immediately call your gas supplier from a neighbor's phone. Follow
the gas supplier's instructions.
To Turn Off Gas To Appliance:
3. Push in gas control knob slightly and turn
clockwise to "Off". Do
not force.
4. Replace the lower horizontal access panel.
1. Turn off remote switch.
2. Lift out the lower horizontal access panel
.
1.
STOP!
Read the safety information above on this label.
2.
Lift out the lower horizontal access panel
.
3.
Push in gas control knob and turn clockwise
to "OFF."
4.
Wait five (5) minutes to clear out any gas. Smell for gas, including near
the floor. If you then smell gas,
STOP!
Follow "B" in the safety information
above on this label. If you don't smell gas, go to the next step.
5.
Locate pilot burner
(See illustration at right.)
and follow steps below.
6.
Turn knob on gas control counter clockwise
to "PILOT."
7.
Push in gas control knob completely and hold. Light with piezo igniter
button. Continue to hold the control knob in for about (1) minute after the
pilot is lit. Release the knob and it will pop back up. Pilot should remain
lit. If it goes out repeat steps 3 through 8.
•
If knob does not pop up when released. Stop and immediately call
your service technician or gas supplier.
•
If the pilot will not stay lit after several tries, turn the gas control
knob to "OFF" and call your service technician or gas supplier.
8.
Push in gas control knob and turn counter-clockwise
to "ON."
9.
Replace the lower Horizontal access panel.
10.
Turn on remote switch to ignite fire.
Lighting Instructions:
with Continuous Pilot
For Your Safety - READ BEFORE LIGHTING:
NOTE:
Gas control knob cannot be turned from
"PILOT" to "OFF" unless knob is pushed
in slightly. Do not force.
