Page 6
Vista 38 ST See-thru Gas Fireplace
rev.110331
Installation
Installing Terminations with Built-In Frames
Installing Terminations with MSR Frames
12
12
1. Frame the termination opening to 12" x 12".
2. Fasten the termination to the studs using a minimum of 4 screws.
11
11
1. Frame the termination opening to 11" x 11".
2. Fasten the termination to the studs using a minimum of 4 screws.
Installing Terminations with MOSR Frames
12
12
12
MOSR
1. Frame the termination opening to 12" x 12".
2. Fasten the MOSR frame to the interior side of the studs using a minimum of 4
screws.
3. Insert the termination into the MOSR frame as shown here, and attach by
screwing through the four pilot holes in the termination.
MSR
PTO-4F (5"/8")
PTO-4 (5"/8")
PTO-4 (5"/8")
PTKOG (5"/8")
Installing Heat Guards over Terminations
Figure 4a.
Installing a PTO termination.
Figure 4b.
Installing a PTO termination with the MSR frame.
Figure 4c.
Installing a PTO termination with the MOSR frame.
Figure 4d.
Installing a PTO termination heat guard.
Caution:
Vent terminations can be very hot. If the termination is less than 7 feet above a
public walkway, it should be fitted with a certified European Home Heat Guard.
(Part no. PTKOG).
Do not obstruct, or attempt to conceal the vent termination. These actions
will affect the operation of the fireplace, and may be hazardous.
In heavy snow areas, take extra care to prevent snow buildup from obstructing
the vent termination.
Use European Home Vinyl Heat Shield (Part no. VSS) when using on applica-
tions with vinyl siding to guard against possible damage.
CAUTION:
Do not obstruct, or attempt to conceal, the vent termination. These actions
will affect the operation of the fireplace, and may be hazardous.
In heavy snow areas, take extra care to prevent snow buildup from obstructing
the vent termination.
CAUTION!
Due to its high operating temperatures, the appliance should be
located out of traffic and away from furniture and draperies.
Children and adults should be alerted to the hazards of the
high surface temperature, which could cause burns or clothing
ignition.
Young children should be carefully supervised when they are in
the same room as the appliance.
Clothing or other flammable materials should not be placed on
or near the appliance.
