32
LIGHTING AND OPERATION
LIGHTING THE FIRE
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance is equipped with an ignition device that automatically lights the pilot. Do not try to
light the pilot by hand.
B. BEFORE OPERATING THE BURNER SYSTEM, smell around the appliance area for gas. Be sure to
smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light the appliance.
Do not touch any electric switch; do not use any telephone in your building.
Immediately call your gas supplier from a neighbor’s telephone. Follow the gas supplier’s instruc-
tions.
If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to operate the gas controls. Never use tools. If a knob will not push in or turn by
hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a
fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service techni-
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
1. STOP! Read the safety information in A, B, C, & D above.
2. This appliance is equipped with an ignition device that automatically lights the pilot. Do not try to
light the pilot by hand.
3. If using the Remote Handset, push the
button until you hear an audible signal to insure the
appliance is off.
4. Wait five (5) minutes to clear out any gas. Then smell for gas including near the floor. If you smell
gas, STOP! Follow “B” in the safety information above. If you don’t smell gas, proceed to step 5
or 6.
5. If you are using the Remote Handset, press “ON” button followed by “OK” button on the Remote
Handset. An audible signal confirms the start sequence has begun.
6. If you are using the Manual Control Panel, push the ON/OFF (top) button on the Manual Control
Panel (See Fig. 2) An audible signal confirms the start sequence has begun; release button.
7. Once the pilot is lighting, check for proper pilot flame appearance, see Fig. 3. To light the main
burner press the button on either the Manual Control Panel, or Remote Handset.
NOTE: If the pilot does not stay lit after several tries, proceed to step 10.
8. Use the flame height adjustment buttons on either the Remote Handset or the Manual Control Panel
to adjust the flame. Press the button to decrease the flame height, press the button to in-
crease flame height. The Remote Handset can also be used to control the appliance thermostatically.
9. Press the button 3 times on either the Manual Control Panel or Remote Handset to set the appli-
ance to pilot flame only.
10. If the appliance will not operate, follow the instructions “TO TURN OFF GAS TO THE APPLI-
ANCE” and call your gas service technician or gas supplier.
