33
LIGHTING AND OPERATION
PILOT AND MAIN BURNER OPERATION
Follow the lighting instructions on pages 32 and 33. When the pilot is
lit and operating properly, it should look like the adjacent illustration.
One flame will be directed at the pilot thermocouple and a second
flame is directed toward the burner. If the pilot flames do not resem-
ble those in the adjacent illustration, contact your gas service techni-
cian or West End dealer.
After the main burner has been in operation for a few minutes, the
flames should look like those in the illustration below. Note: The
flame height will vary depending on the firing rate setting but flames should be evenly distributed across
the full width of the burner.
FIG. 1
FIG. 2
FIG. 3
CORRECT PILOT
FLAMES
10. To turn the appliance off completely, push and release the “OFF” button on either the Remote Handset
or Manual Control Panel . You will hear an audible signal confirming the off setting.
11. TURN OFF GAS TO THE APPLIANCE by closing the shut-off valve on the gas supply line to the ap-
pliance and call your service technician or gas supplier.
OFF
O.K./UP
ON/DOWN
