70080000 Manual Sogno DreamWave Spa
Rev A
Revision Date: 25 March 2010
Page 22 of 42
R
EMOTE
C
ONTROL
D
ISPLAY
Information, such as massage action descriptions, status of progress, and the intensity and speed of the
massage in progress, is displayed with both characters and symbols.
Characters and symbols on the display move from right to left.
Example: While the Shiatsu Point Locator sensors are being activated, the display shows the following text:
“Locating Shiatsu Points...”
Remote Control Display:
R
EMOTE
C
ONTROL
/I
NSIDE
T
HE
P
ANEL
Basic Operation Buttons
Air Massage Buttons
You can select from among
[Shoulder], [Arm], and [Seat]
* The intensity of air massage
can be adjusted in three steps
(high, medium, and low)
Heater Button
For turning the heater under
the seat ON or OFF
Speed Button
For adjusting the roller speed in
three steps during Kneading,
Tapping 1, and Kneading &
Tapping
Width Button
For adjusting the width of the
rollers in three steps
Rolling Button
You can select from between
Full and Partial Rolling
Back Vibe Button
For back vibration operation
* The intensity of vibration can
be adjusted in two steps (high
and low)
MUTE Button
For turning the speaker of the
remote control ON or OFF
Before Use
•
This product is shipped with the reclining seat back in its fully reclined position and with the armrests
removed. Before use, be sure to attach the armrests (refer to the insertion sheet attached) then raise the
seat back to its upright position.
•
Do not expose the chair to sudden bursts of heat. If the room where the chair is to be used is cold, turn the
heat up lowly. If the chair is moved from a cold place into a heated room, wait one hour before using the
chair.
Ö
Condensation could occur in the moving parts of the product, which may compromise performance.
