202002-400-ENG
User manual - JETPRO 100-7, 120-7, 130-7
P11
4. USE OF THE MACHINE (continued)
4.2. STARTING UP (continued)
START-UP
1.
Put soapy water into the tank.
2. Plug in the machine.
3.
Disconnect the electric connector which is at the spray-gun (plug beneath the electric box)
4. Open the spray-gun.
5.
Set the product flow-rate on the display (A1) to 30 with help of the b/- (4) or (5).
6.
Push the button MANU/AUTO (2) the warning light (L2) lights up. The drive shaft at the bottom of
the tank must turn. If this is not the case, see 4.1. on page 10.
7.
Push once again on the button MANU/AUTO (2) to switch to AUTO mode, the warning light (L3)
lights up.
8. Put your product in the tank.
9.
Switch the machine to MANU mode until the product comes out of the spray-gun.
10.
As soon as the product comes out of the spray-gun, switch to AUTO mode.
11. Close the spray-gun, reconnect the electric connector
12. Put the nozzle-carrier onto the spray-gun and use the desired nozzle for the used product.
13.
Set the working pressure on the display (A1) to 60 with help of the b/- (4) or (5).
14.
Open the spray-gun and verify that the warning light (L6) lights up, then start to atomize.
15. Adjust the pressure to your needs.
4.3. ERROR CODES
The different error codes show up on the display (A1).
CODES
DEFINITION
TO DO
No display.
Plug the machine into the power supply, assure the power supply is
230 V, verify the fuse in the electric box.
Emergency stop is
on.
Unlock the emergency stop button (AU).
Machine is in the
stop mode.
Switch the machine on by pressing on the button (1).
Default control
engine.
Set the machine to "OFF" for one minute and then switch it back on.
Default command
departure.
Verify that the lance is closed when the macine is switched on.
If the problem persists or if in doubt on the good running of the machine, do not try to repair
it by yourself or to dismantle it.
Contact an authorized After-Sale Service or our hotline : +33 4 42 29 08 96.
