Advanced Configuration
VoIP²ALL 8 - 16 - 24 Channel Gateway User Guide
www.eurotech-communication.com
40
There are two common methods of counting units:
seconds
minutes
If you are workiing by seconds and you want to limit the Current Balance to a specific number of
minutes, the Current Balance (units) must be the number minutes X 60.
To configure a SIM from the SIM Server to work in Call Duration:
1)
On the Main Toolbar, click
Virtual SIM
.
2)
Select the
Profile
tab.
3)
In
Server Profiles Selection
, select a profile.
4)
Click + next to the
SIM Prepaid
parameter of the profile.
5)
Click + next to
Balance Recharge
.
6)
Click + next to
Charge Calculation
.
7)
Click + next to
Billing
.
8)
Define the following parameters:
Primary Bill Interval
Primary Interval Count
Primary Cost per Bill Int
Secondary Bill Interval
Secondary Cost per Bill Int
9)
Click
Save.
10)
Assign the profile to a SIM. See
Assigning a Profile to a SIM
on page 37.
11)
Define the Current Balance.
12)
Click
Save Card.
13)
Define the
Call Duration
list.
To define the Call Duration SIM list:
1)
On the Main Toolbar, click
Ports
.
2)
From the ports list on the left, select a port.
3)
In
Type
, select a Time Table type.
4)
In
Swapping Type
, select
Call duration
.
5)
In
Available SIMs
, select a SIM.
6)
In the Time Table, click a cell. A dialog box appears.
7)
In the dialog box, enter the amount of units you want to limit the SIM to that day.
In the time slot you can see the information of the SIM in this format:
C1_S1_100\100_192.168.0.31
