Advanced Configuration
VoIP²ALL 8 - 16 - 24 Channel Gateway User Guide
www.eurotech-communication.com
55
4.9.2.
PORT TEST CALLS
The Test Call feature randomly generates calls from the cellular ports to predefined destinations. You
can use this feature to test incoming calls to the cellular ports.
To setup the Test Call:
1)
On the Main Toolbar, click
Ports
.
2)
In the ports list, select
General
.
3)
Select the
Test Call
tab.
4)
Select the ports to call by clicking the check box next to the port in the table.
5)
In
Call Numbers
, enter the list of numbers to call from the selected ports.
6)
In the
Call Timers
, define the following parameters for the calls:
Length of Calls
- The minimum and maximum length of the calls. A call lasts a random
amount of seconds within this range.
Frequency of Calls
- The minimum and maximum length of time between the calls. The time
between calls will be a random amount of seconds in this range.
Start Time
- The time to start the calls.
End Time
- The time to stop the calls.
7)
Click
Save Settings
.
8)
Click
Active
to start the Test Calls.
9)
To stop Test Calls, click
Stop
.
4.9.3.
SOURCE ROUTING
Using the Source Routing feature, you can direct calls according to their calling number or IP address
from where the call originated, rather than the destination of the calls (i.e. the prefix of the dialed
number).
Note: When the Source Routing is enabled, all the settings in the prefixes window are irrelevant and
the Gateway stops routing calls according to prefixes.
Source Routing functions as follows:
A call comes from any cellular port or VoIP.
When the calling number is in the range of defined numbers or IP addresses, the Gateway routes the
call to the port that is defined for this range.
If more than one port is defined, the Gateway divides the calls between the ports.
If there are no available ports, the Gateway declines the call and you will hear a busy tone.
Note: When using Source Routing by IP, the Gateway only routes SIP calls.
To configure Source Routing:
1)
On the Main Toolbar, click
Ports
.
